Why We Built It: Solving the RX7 FD Front Lip Gap Forever
Carbon Street didn't start as a corporate business venture. It started as two mates in a garage, working on our RX7s, chasing the elusive look of an OEM+ aesthetic — making sure not to compromise the look Mazda intended.
The Problem: The Infamous 2-Piece Lip Sag
The factory Mazda 2-piece front lip was designed in the early 90s. Decades later, heat, road debris, and the weight of the front bar cause the OEM plastic to warp. If you've installed a front mount intercooler (FMIC), you know the struggle: constant trimming and refitting weakens the bar's structural integrity, leading to the dreaded "center split" — a visible gap right in the middle of your car's face.
This split causes:
- Visible panel misalignment
- Structural flutter at high speeds
- An incomplete look that ruins the FD's iconic flow
The Solution: The Carbon Street 1-Piece Carbon Fibre Front Lip
We didn't set out to reinvent the wheel — we wanted to perfect it. We listened and learned from our customer base and the wider RX7 FD community.
Why this is the ultimate FD3S exterior upgrade:
- ✅ Zero Gap: Seamless 1-piece design that stays flush forever
- ✅ OEM+ Fitment: Uses all factory mounting points — no custom drilling required
- ✅ Restores the RX7's original design flow
Engineering for car mods has evolved and your car should too. An Australian-first, designed by enthusiasts for enthusiasts.
Ready to Transform Your RX7's Front End?
Limited Pre-Orders Are Now Open
Secure your spot in the first production batch. Don't wait — this is an Australian-first, limited-run product.